1989 Chevrolet Corvette V8-350 5.7L
Steering Column: Service and Repair
Disassembly/Assembly
SHAFT LOCK, TURN SIGNAL CANCELLING CAM, UPPER BEARING SPRING, UPPER BEARING SEAT & INNER RACE
Disassembly
1. Remove steering wheel as follows:
a. Disconnect battery ground cable, then remove horn cap from steering wheel by pulling.
b. Disconnect horn button wire, then remove telescope lever screws and shaft lock knob screw.
c. Remove telescope adjustment lever, steering wheel nut retainer and nut.
d. Remove steering wheel with a puller.
2. Remove spacer, bumper, spacer and snap ring retainer (Nos. 2, 3, 4, and 5 in Fig. 59).
3. Remove shaft lock retainer using lock plate compressor to depress shaft lock.
4. Remove shaft lock and carrier assembly, upper bearing spring, upper bearing seat and inner race.
5. Reverse procedure to install.
TURN SIGNAL SWITCH
Disassembly
1. Remove SHAFT LOCK, TURN SIGNAL CANCELLING CAM, UPPER BEARING SPRING, UPPER BEARING SEAT & INNER RACE as previously outlined. Download File PDF
0 Comments