1992 Chevrolet Corvette Distributor Removal & Installation
See Figures 1, 2, 3, 4 and 5
For 1995-96 vehicles, inspect the distributor ventilation system 1. for proper ventilation.
2. Be sure the ignition is in the OFF or LOCK position. Disconnect the negative battery cable.
3. Detach the Intake Air Temperature (IAT) electrical connector.
4. Remove the air intake duct.
Fig. 1: Unfasten the retainers, then remove the air intake duct
5. Remove the accessory drive belt, as outlined in General Information & Maintenance of this repair guide.
6. Drain the engine cooling system into a suitable container.
7. Disconnect the water pump coolant hoses, and allow any remaining coolant to drain.
8. Detach the Engine Coolant Temperature (ECT) sensor electrical connector.
9. Remove the water pump and crankshaft balancer, as outlined in Engine & Engine Overhaul of this repair guide.
10. Remove the drive belt tensioner.
11. Label and disconnect the spark plug wires/harness from the distributor.
12. Unplug the 4-terminal ECM/PCM electrical connector from the distributor. .. Download File PDF
0 Comments