1995 Pontiac Firebird V6-204 3.4L VIN S SFI
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement (3X)
REMOVE OR DISCONNECT
1. Disconnect negative battery cable.
2. Remove starter motor.
3. Disconnect sensor harness connector at module.
4. Remove sensor to block bolt.
5. Remove sensor from engine.
Inspect
Inspect sensor O-ring for wear, cracks or leakage. Repace as needed. Lube new O-ring with clean engine oil before installing.
INSTALL OR CONNECT
1. Sensor into block.
2. Install bolt.
Tighten
Bolt to 8 Nm (71 lb. in.)
3. Connect sensor harness connector at module.
4. Install starter motor.
5. Connect negative battery cable. Download File PDF
0 Comments