1994 Mazda 626 L4-1991cc 2.0L DOHC
TIMING BELT REMOVAL / INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the camshaft position sensor and crankshaft position sensor.
3. Remove the spark plug.
4. Remove the P/S oil pump and bracket with the oil hose still connected.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Verify the air gap.
8. Start the engine and
(1) Inspect for the pulleys and drive belt for runout and contact.
(2) Verify the ignition timing.
Crankshaft Pulley Removal Note
- Hold the crankshaft by using the SST.
CAUTION: The crankshaft position sensor rotor is on the rear of the crankshaft pulley, and can be damaged easily. Download File PDF
0 Comments