Superlift 4” lift system for 1998 - 2009 FORD RANGER 4WD with torsion bar front suspension
INSTALLATION INSTRUCTIONS
FRONT DISASSEMBLY
1) PREPARE VEHICLE...
Place vehicle in neutral. Raise front of vehicle with a jack and secure a jack stand beneath each frame rail, behind the lower control arms. Ease the frame down onto the stands, place transmission in low gear or “park”, and chock rear tires. Remove front tires.
2) TORSION BAR REMOVAL...
On each side, scribe alignment marks to note the torsion bar’s indexing in relation to the adjuster arm. Also scribe marks to note the front end of the bar in relation to the lower control arm.
Label the bars (front / rear end, and driver / passenger side) because they must be reinstalled in the same position and orientation as they were removed.
[DIAGRAM 1] Remove the plate that covers the torsion bar adjuster arm assembly. The plate and attaching hardware will be reused, but not in the same location. So go ahead and remove the nut clips from the crossmember lips [DIAGRAM 7].
[DIAGRAM 2] Load the bars using a torsion bar puller tool (discussed in the NOTES section above) and remove the adjusting bolt and nut block. Unload the bar. Download File PDF
0 Comments