How to Replace the Oxygen Sensor on a Pontiac Montana

The oxygen sensor in your Pontiac Montana is a very important component to keep your engine and vehicle running smoothly. The oxygen sensor sends signals to the engine control unit to determine if the vehicle needs to adjust the air and fuel mixture. The sensor is primarily responsible for monitoring the amount of unburned oxygen in the exhaust as it exits the engine. When the Pontiac Montana oxygen sensor begins to fail or goes bad, it will affect how well the vehicle drives, along with fuel consumption. Replacing the oxygen sensor is crucial to keep your Montana running efficiently.

Step 1 - Allow the Montana’s engine to cool for 10 minutes. The engine will still be warm to the touch, however this is necessary since the oxygen sensor is easiest to replace while the engine is warm.

Step 2 - Locate the exhaust manifold; the oxygen sensor is positioned on top of the manifold. Refer to your Montana owner’s manual if needed.

Step 3 - Using a socket wrench and an oxygen sensor socket, loosen the oxygen sensor. Use a 22 mm socket if you do not have access to an oxygen sensor socket. Continue to loosen the oxygen sensor until the you can easily remove the sensor by lifting it off the manifold.

Insert the new oxygen sensor into the connector and push in to ensure the sensor plugs into place. Close the hood of the Montana.

THINGS YOU'LL NEED: Wrench, Oxygen sensor socket or 22 mm socket, Owner’s manual

Post a Comment