2006 Acura TL
DRIVER'S AIRBAG REPLACEMENT
REMOVAL
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.
3. Remove the two Torx bolts (A) using a Torx T30 bit.
4. Disconnect the horn switch connector (1P), then remove the driver's airbag (B).
INSTALLATION
1. Connect the horn switch connector (1P) (A) to the driver's airbag.
2. Place the driver's airbag (B) in the steering wheel, and secure it with new Torx bolts (C).
3. Connect the cable reel 4P connector (A) to the driver's airbag 4P connector, then install the access panel (B) on the steering wheel.
4. Connect the battery negative cable.
5. Connect the HDS and erase the DTCs.
6. After installing the airbag, confirm proper system operation:
- Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off. Download File PDF
0 Comments