Removing, installing
1. Press of handle recess (3) using assembly wedge
2. Unscrew screw (4) in the area of the interior door control
3. Unclip cover (11) and unscrew screw (12) With code 293 (rear side airbag)
4. Unscrew screw (1) on lock escutcheon (2) and remove lock escutcheon (2)
downwards
5. Press of cover (5) under armrest and unscrew screw (6)
6. Unclip entrance lamp and disconnect elctrical cable
7. Press door lining (8) off inner door panel at bottom, front and rear using assembly
wedge Guide each assembly wedge straight to the clips
8. Lift door lining (8) out of retaining clips at the top of the sealing rail using assembly
wedge and at the same time pull away from the inner door panel
9. Unhook control cable (14) on interior door control Installation: Ensure that the
control cable (14) is clipped into the retaining clip (13)
10. Pull electrical connections off door lining (8)
11. Put down door lining (8)
12. Check film and clips on inner door panel and replace if necessary. Stick door film
onto inner door panel.
13. Check clips (9) on door lining and replace if necessary
14. Install in reverse order Download File PDF
0 Comments